|
|
Post by oldfart on May 7, 2006 9:02:14 GMT 1
Clutching at straws here I feel - but anyone know of a useable early bay beam going spare? Mines a little perforated  Cheers. |
|
|
|
Post by slimebomb on May 7, 2006 20:34:02 GMT 1
Is mine no good for you? from a 72.
|
|
|
|
Post by oldfart on May 8, 2006 11:19:07 GMT 1
I dont think it will fit - I've compared mine to a '73 disk beam and its very different. Could you take some measurements off yours to check? Fixing bolt centres - mine are (all approx) Top hole to bottom hole - front and back - 95mm Top holes - 125mm Bottom holes - roughly 160mm Between the cheeks  - 745mm If yours is the same consider it sold  Cheers |
|
|
|
Post by slimebomb on May 8, 2006 18:30:18 GMT 1
should be up at the garage tomorrow so if i remember to take my measure i will do it.
|
|
|
|
Post by slimebomb on May 11, 2006 17:50:25 GMT 1
I dont think it will fit - I've compared mine to a '73 disk beam and its very different. Could you take some measurements off yours to check? Fixing bolt centres - mine are (all approx) Top hole to bottom hole - front and back - 95mm Top holes - 125mm Bottom holes - roughly 160mm Between the cheeks - 745mm If yours is the same consider it sold Cheers Nah mate mine are 125mm not 95 not sure what your other measurements are but the between cheeks measure the same, so dont think it'll fit. Soz. |
|
|
|
Post by oldfart on May 11, 2006 19:23:42 GMT 1
T'is OK, thanks for looking any way. I've decided to test my fabrication and welding skills to the limit and try to fix it  . Hope to be at Shauns in it on Sunday - but may be in the Crapmobile    |
|
- 745mm
. 
